1979 Johnson Where Can I Find The Prop Shaft Seal In A Lower Unit Of A 1979 Johnson 35 Hp?

Where can i find the prop shaft seal in a lower unit of a 1979 Johnson 35 hp? - 1979 johnson

There are two back-to-back (an oil seals keep the other in order to) keep the water, the level of the company.

So do not jump at the end of the propeller shaft (away) prop you to the company. There must be two 5 / 16 "screws go through the company's website takes a long extension to remove. Screws O-rings be replaced during reassembly.

The carrier has a tight fit is extremely tight - you may find that you need to take on the outside of the gearbox with a light in the Society of heat. Try not to overheat the transmission.

You get a hood of art must (a little money in any business auto parts) - if your company has two threaded holes in the web, you can use a couple of verylong screws with the shooter (I do not know the size of the wire into the holes, but should not be too hard to understand), or if you have a pair of arms, which must be connected directly to the website company.

After the deal was done, check the seals on the beach - no discoloration at all, chicken with fine sandpaper. Do not worry, you can not remove any axis material speak of something else, the labels will not close.

Use a screwdriver to remove the old seal of the company.

Shield Plane shipping two new faces with good fat (fat-axle trailer is not sealed) and outer surfaces with 3M # 847th Press the flat side of the first edition * * and the second flat

Use a pair of 1 / 4 & quot, threaded rods through the holes and bolt holes in the bolt head back to the company's position in the transmission.

Add new O-rings keep the company screws, coat the threads with blue Loctite and lock in.

Add a little grease on the shaft, reinstall prop, and fishing!