How do i bled the injector pump on an 986 international Harvester?< It will not start unless we use ether? - international harvester wall border
We never had to use ether to start and it started a few weeks ago
How do i bled the injector pump on an 986 international Harvester?< It will not start unless we use ether? - international harvester wall border
We never had to use ether to start and it started a few weeks ago
Copyright 2009 Hummingbird iron Information. Powered by
Blogger.
Blogger Templates created by Deluxe Templates
Wordpress theme by digitalnature
1 comment:
Is it mechanical injectors? or electronically?
I propose to ensure that the filters are clean and fuel pressure is good. and ensure that the injector screw up as a point or clean dirt / trash. They also tend to engage in the gums, or mud to be cleaned.
In general, while loosening the top of the line pressure in a nozzle at a time, until the air is pumped
You can also check and replace the glow plugs. Preheat the cylinder, as in the first start or cold start a bit like a spark plug with a wire stuck into her, and the bottom is rounded and not a snap of a gap
Hope this helps
Post a Comment